Both will appear with yellow icon (usually under Other), indicating that Windows failed to install drivers for them.
Xhorse Electronics Mvci Windows 10 And ThenHe came on TeamViewer and helped get it working on my windows surface running Windows 10 and then helped me with the driver for the cable.I had been looking at the Mangoose VCI and the Mini VCI as options but I have Win10.
![]() I just want to make sure to get one that gives me the best chance to make it work. However, I dl an even newer version of Techstream, 12.20.024, from this link and followed the directions in the OP in this thread. I did it on Windows 10 and there were a few hiccups. Xhorse Electronics Mvci .Exe So IThere was no Firmwearupdatetool.exe so I had to skip that step. The names of the devices were not the same. I found Universal Serial Converter under the Universal Serial Bus Controllers heading and USB Serial Port under Ports (COM LPT) and made sure it was COM4 (use the advanced button under port setting of the properties to change it. I tried to do the update driver on each and point to the xhorse directory, but both said the current driver was newer. I did do the registry updatemerge and once I did that it worked. As to the key, there is a txt file that has the key in it that you have to use to activate it. Instructions.txt) I connected my 2012 Camry as it sit the newest Toyota we have and TEchstream worked flawlessly. For reference, the DLC3 cable diagnostic showed only K and L as red, while all the rest, including CAN-L and CAN-H as green. So, I can confirm that it DOES work in Win 10, you just need to wiggle it a bit to make it work.:-). Struggled with the thing all day till came across this thread. Did not have any device installation issues, but did have to merge the reg key to make this work. As far as i know none of us have been able to program TPMS ids with one of the cheap cables. Been struggling for a while trying to registering TPMS IDs with Techstream using a knock-off cable. Xhorse Electronics Mvci Manual Tweaking ItAs it turned out, with little manual tweaking it is possible, contrary to the popular belief, to get it working under Windows 64-bit. So, I decided to share the instructions, which hopefully will save someone a headache of dealing with dual boot and virtual machines with Windows XP. The cable is about 4 long, with translucent casing and MINI-VCI J2534 Standard OBDII Communication Interface sticker: The cable comes with a mini CD with drivers and Toyota Techstream software. Mine was advertised as Newest V8.00.034 MINI VCI for TOYOTA TIS Techstream Diagnostic Cable Software. The newest refers to the version of bundled Techstream, rather than the cable firmware, as cable shows serial number MVCI006000001 and firmware version 1.4.1, which is widely known as cheap clone of the original XHorse MVCI cable. Mine is actually Windows 8 x64, but for Windows 7 the configuration procedure should be identical. Once executed, it simply unpacks and copies the IT3System.ini file to the Techstream folder. The workaround is to install it manually, as follows: Open Command Prompt in Administrator Mode. Navigate to the c:temp folder and run the following command line: msiexec a C:tempMVCI Driver for TOYOTA.msi qb TARGETDIRc:tempmvci This will extract the content of the MSI file to the c:tempmvci folder.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |